User`s guide

User Guide
123
www.bull.com
When performing a Span, create two or more sets of the same pack at the pack
creation, as shown in the figure below.
Figure 40: Spanning of RAID1
8. When all the settings are completed, select Accept and then press Enter to
create the logical drive.
The created logical drive is displayed in the Logical Drive Configured screen.
9. After creating a logical drive, press Esc to close the screen.
Go back to the Save Configuration? screen and then select Yes to save the
configuration.
10. Once it is confirmed that the configuration has been saved, press Esc to return
to the Top menu screen.
11. On the Top menu screen, select Objects → Logical Drive → View/Update
Parameters to check the logical drive information.
12. Select Initialize in the Top menu screen.
13. When the Logical Drives screen appears, move the cursor to the logical drive
to be initialized, and press Space.
The logical drive is selected.
14. Press F10 to start the initialization, and press Yes when prompted to do so.
When the progress bar in the Initialize Logical Drive Progress screen reaches
100%, initialization is completed.
15. Execute a Check Consistency on the logical drive that has been initialized.
Refer to “Check Consistency” on page 127 for more information.
16. Press Esc to return to the Top menu and exit the LSI Logic Software RAID
Setup Utility.
Caution
■ Be sure to execute a Check Consistency after creating a
configuration.
■ Check Consistency has two modes: "check and recover"
and "check only".