User`s guide

User Guide
117
www.bull.com
RAID Configuration using the LSI Logic
Software RAID Configuration Utility
Use this utility to set up the RAID configuration of your hard disk drives.
Note: This utility cannot be run via the remote console
feature of DianaScope.
Running the Setup Utility
1. Press Esc when the full screen logo appears after you have powered on the
server.
The POST screen appears.
2. Check the description shown on the POST screen, and then press Ctrl + M.
The LSI Logic Software RAID Setup Utility starts.
Figure 35: LSI Logic Software RAID Configuration Utility
TOP Menu (Management Menu)
Note: To exit the utility, press Esc in the TOP menu of LSI
Logic Software RAID Setup Utility. Select Yes, and then press
Ctrl + Alt + Delete to reboot the server when prompted to do
so.
Tree Menu
+: Selection/execution parameter
←: Setting parameter.
•: Information display
>: Can be set (modified) after creation of logical drive