User`s guide

User Guide
110
www.bull.com
Available options are as follows:
- Create new RAID-1:Default
- Copy from (X) to (Y):Copy data from the disk of ID X to that of ID Y.
- Copy from (Y) to (X):Copy data from the disk of ID Y to that of ID X.
Caution
Double-check the copy source and copy destination. If they are
incorrect, the data will no longer be restored.
3. Enter the desired RAID Name in [Assign RAID Name] window and press
Enter.
Caution
■ A RAID Name must be unique, and up to 15 characters are
acceptable.
■ If a valid partition information or a boot block is detected in
the selected hard disk drive, a warning message will be dis-
played. Select [Yes] to continue creating an array, or [No] to
cancel the array creation.
■ Take to select the appropriate hard disk drives. If not, the
data will not be restored.
4. The message "Do you want to make this array as bootable?". Select either
[YES] or [NO], and then press Enter.
Note: The boot priority can be changed after the arrays
have been created. Refer to “Boot Priority” on page 115.
5. When prompted with the message [Create Array?], select [Yes] and press
Enter.
Selecting [No] cancels the array creation and returns to the Main menu.
6. When prompted with the message [Are you sure?], select [Yes] and press
Enter.
Selecting [No] cancels the array creation and returns to the Main menu.