User`s guide

User Guide
108
www.bull.com
2. Use the cursor key to highlight the desired hard disk drives, press Space to
select them (an [X] mark is placed next to the selected hard disk drive) and
when the selection is finished, press Enter to validate it.
.
3. Select the desired stripe size and press Enter. Available stripe sizes are 16, 32,
and 64 KB.
4. Enter the desired RAID Name in [Assign RAID Name] window and press
Enter.
Caution
■ A RAID Name must be unique, and up to 15 characters are
acceptable.
■ If a valid partition information or a boot block is detected in
the selected hard disk drive, a warning message will be dis-
played. Select [Yes] to continue creating an array, or [No] to
cancel the array creation.
■ Take to select the appropriate hard disk drives. If not, the
data will not be restored.
5. The message "Do you want to make this array as bootable?". Select either
[YES] or [NO], and then press Enter.
Note: The boot priority can be changed after the arrays
have been created. Refer to “Boot Priority” on page 115.
6. When prompted with the message [Create Array?], select [Yes] and press
Enter.
Selecting [No] cancels the array creation and returns to the Main menu.