User`s guide

User Guide
86
www.bull.com
Setting a Hot Spare
1. Install a hard disk drive to be used as hot spare, and then power on the server.
2. Run the LSI Logic Software RAID Setup Utility.
3. Select Objects → Physical Drive from the TOP menu.
The Objects - Physical Drive Selection Menu screen appears.
Figure 33: Objects - Physical Drive Selection Menu screen
4. Move the cursor onto the hard disk drive to be used as hot spare and press
Enter.
5. The "Port #X" screen appears. Select Make HotSpare.
6. Select Yes when prompted to do so.
The hard disk drive indication changes to "HOTSP."
Install a hard disk drive
Run the LSI Logic Software RAID Setup Utility
Set for hot spare.
Exit the LSI Logic Software RAID Setup Utility