User`s guide

User Guide
82
www.bull.com
5. Press Space.
SPAN-1 is set.
Figure 29: Select Configurable Arrays screen
6. Press F10 to create a logical drive.
The Logical Drives Configure screen appears. (The figure below shows an
example of a RAID1 configured with two hard disk drives.)
Figure 30: Logical Drives Configure screen
7. Select RAID, Size, DWC, RA, or Span by using cursor keys. Then press Enter
to fix the selection and set each value.
(1) RAID: Sets the RAID level.
The selectable RAID level varies depending on the number of hard disk drives
that configure a pack.
(2) Size: Sets the logical drive size.
Up to 40 logical drives can be created per disk array controller.
Parameter Remarks
0 RAID0
1RAID1
10 Spanning of RAID1