User`s guide

User Guide
77
www.bull.com
RAID Configuration using the LSI Logic
Software RAID Configuration Utility
Use this utility to set up the RAID configuration of your hard disk drives.
Note: This utility cannot be run via the remote console feature of
DianaScope.
Running the Setup Utility
1. Press Esc when the full screen logo appears after you have powered on the
server.
The POST screen appears.
2. Check the description shown on the POST screen, and then press Ctrl + M.
The LSI Logic Software RAID Setup Utility starts.
Figure 26: LSI Logic Software RAID Configuration Utility
TOP Menu (Management Menu)
Note: To exit the utility, press Esc in the TOP menu of LSI Logic Software
RAID Setup Utility. Select Yes, and then press Ctrl + Alt + Delete to reboot
the server when prompted to do so.
Tree Menu
+: Selection/execution parameter
←: Setting parameter.
•: Information display
>: Can be set (modified) after creation of logical drive
Table 3: Tree Menu
Menu Description
+Configure Performs Configuration settings
+Easy Configuration Set configuration (Using fixed value)