User`s guide

User Guide
60
www.bull.com
6. Fix the front cover with four inch screws (#6-32UNC).
Figure 19: Fixing the front cover
Assembling the Front and Rear Parts of Support Rails
The support rails are made of a front and a rear part. Those two parts may be adjusted
to fit the distance between the front and rear vertical rails of the rack.
1. Assemble the front and rear parts of the right support rail with 3 self tapping
screws and 3 flat washers.
Figure 20: Right support rail, front and rear parts
Note: When using self-tapping screws, we recommend you tighten the screw
for 3 quarters of a turn, and loosen for 1 quarter. Repeat this cycle until the
screw is completely tightened.
2. Adjust the total length to fit the distance between the front and rear vertical
rails of the rack before securing the screws.
3. Assemble the left support rail the same way.