User`s guide

User Guide
22
www.bull.com
7. USB connectors.
The USB connectors are connected with devices accepting the USB 2.0
interface.
8. Management LAN port.
The LAN connector is connected with management LAN (100BASE-TX/
10BASE-T).
Rear Lamps Indication
Network ports
Figure 7: Rear panel lamps
1. LINK/ACT lamp
This lamp indicates the state of each network port normally equipped with the
server.
Lights green: the server and the hub are correctly connected with each other
(LINK state).
Blinks green: information is transmitted through a network port (ACT state).
Note:
•
If the lamp does not light in the LINK state, check the network cable and
the cable connection.
• If the lamp still does not light, the network (LAN) controller may be
defective. Contact your service representative.
2. 1000/100/10 lamp
This lamp indicates whether each of the standard network ports is operated
through the 1000BASE-T, 100BASE-TX or 10BASE-T network interface.
Lights amber: the network port is operated through 1000BASE-T.
Lights green: the network port is operated through 100BASE-TX.
Off: the network port is operated through 10BASE-T.