User`s guide

User Guide
18
www.bull.com
Some operating systems may provide the function of switching to a power
saving (sleep) mode. If you press the POWER/SLEEP switch once after the
setting, the system enters the power saving mode. If you press the switch again,
the system returns to the normal state.
8. 3.5-inch floppy disk drive bay.
Not used.
9. USB connectors.
The USB connectors allow the server to connect with USB 2.0 devices.
10. Stabilizers.
Use the stabilizers to prevent the server from falling down. Close the stabilizers
when laying the server down.
Front Lamps Indication
This section explains the indication and meanings of the system lamps located on the
front panel of your system.
Figure 4: Front panel lamps
1. STATUS lamp
Lights green: the server is operating normally.
blinks amber: the server is in abnormal state.
Off: the server is in abnormal state.
Refer to “Diagnostic LEDs” on page 170 to check the meaning and the
procedure for the STATUS lamp indication.
2. LAN access lamp (2)
Lights green: data is being transmitted or received.
3. LAN access lamp (1)
Lights green: data is being transmitted or received.