User`s guide

User Guide
118
www.bull.com
5. Record the type and serial number of the add-in board in your equipment log.
Refer to “T840 E2 Equipment Log” on page 202.
6. Set jumpers or switches on the board according to the manufacturer’s
instructions.
7. Hold the PCI add-in board by its top edge or upper corners. Firmly press the
add-in board into an expansion slot on the server board.
8. Repeat the previous steps until all PCI add-in boards are installed.
9. Attach cables, if necessary.
10. Replace the left side door. Refer to “Removing the Left Side Door” on
page 98.
Removing an Expansion Card
Caution: PCI add-in boards are extremely sensitive to electric static
discharge (ESD) and always require careful handling. After removing the
add-in board from its protective wrapper or from the server board, place it
with the component side up on a grounded, static-free surface or conductive
foam pad. Do not slide the add-in board over any surface.
1. Remove the left side door. Refer to “Removing the Left Side Door” on
page 98.
2. Remove the screw of the retention panel, and open the retention panel.Refer to
“Rear panel” on page 117.
3. Disconnect any cables that may be attached to the PCI add-in board that needs
to be removed.
4. Firmly grab the PCI add-in board by its top edge or upper corners and remove
it from the expansion slot on the server board (A).
Place the removed add-in board in an anti-static protective wrapper.
5. If available, replace the PCI slot shield by pressing the slot shield into the
opening on the chassis.
6. Replace the left side door.