User`s guide

User Guide
117
www.bull.com
Installing an Expansion Card
Note: You may want to install an operating system before installing any PCI
add-in boards.
1. Remove the left side cover. Refer to “Removing the Left Side Door” on
page 98.
2. Remove the screw shown in figure “Rear panel” on page 117, and open the
retention panel.
Figure 59: Rear panel
3. Remove the PCI slot shield, if it has not already been removed, by pushing the
shield out from the inside of the chassis.
4. Remove the PCI add-in board from its protective wrapper.
Caution: Be careful not to touch the components or gold-edge connectors.
Place the board on an anti-static surface.
1- Screw 3- PCI slot shields
2- Retention panel