User`s guide

User Guide
107
www.bull.com
Installation
1. Open the front panel.
2. Fully open the lever of the hard disk drive and insert into the HDD cage until it
hits the rear of the HDD cage.
3. Close the lever to fix the drive (a click occurs when it is locked).
Note: Make sure of the orientation of the hard disk drive tray before inserting
it into the cage. Also make sure that the hooks of the hard disk drive are
engaged with the frame of the HDD cage.
4. Close the front panel.
Removal
Caution: Removing several hard disk drives at the same time while the
server is powered on destroys the logical disk. Remove or replace hard disk
drives one by one.
Caution: About data on the hard disk drive
• Be sure to take appropriate measures not to leak important data (e.g.,
customers' information or companies' management information) on the
removed hard disk drive to any third parties.
• Data seems to be erased when you empty "Recycle Bin" of Windows or
execute the "format" command of the operating system. However, the
actual data remains written on the hard disk drive. Data not erased
completely may be restored by special software and used for unexpected
purposes.
• It is strongly recommended that the software or service (both available
at stores) for data erasure should be used in order to avoid the trouble
explained above. For details on data erasure, ask your sales
representative.
1. Open the front panel
2. Follow steps 2 and 3 of the installation procedure to remove the hard disk
drive.
3. Close the front panel.