User`s guide

User Guide
101
www.bull.com
Installing or Removing a 5.25-inch Device
This section of the chapter describes how to add and remove 5.25-inch devices. You
can install a CD-ROM, DVD-ROM, COMBO DVD-ROM CD-RW or DVD+R9 Drive,
tape backup unit, or other 5-25 inch devices in the additional 5.25-inch bay. See the
installation instructions included with those items for specific installation information.
Adding a 5.25-inch Device
1. Remove the left side door. Refer to “Removing the Left Side Door” on page 98
2. Remove the front panel. Refer to “Removing the Front Panel” on page 100
3. From the inside of the chassis, push on the desired slot cache with your left
hand and hold it with your right hand outside the chassis.
4. Pivot the cache until it gets released from the frame.
Note: The two tabs that hold the cache actually break: this is normal.
5. Removed the two slide rails already screwed in the bay.
6. Attach the slide rails to the upper holes on both side of the 5.25-inch device.
Figure 42: Attaching the Slide Rails
7. Slide in the 5.25-inch device until it clicks into place.
8. Connect the cable(s) to the drive. Refer to “Cabling SATA Devices” on
page 119
9.
Replace the front panel. Refer to “Removing the Front Panel” on page 100
10. Replace the left side door. Refer to “Removing the Left Side Door” on page 98
Note: Modify the BIOS Setup program to recognise the additional device. For
additional information, refer to “BIOS Setup Utility” on page 171.
Removing a 5.25-inch device
1. Remove the left side door. Refer to “Removing the Left Side Door” on page 98