User`s guide

User Guide
93
www.bull.com
10. Place and secure the cabling within the cable arm.
a. Install the sytem in the slide rails, as described in steps 13 to 16 of
“Installing a Rack Mount Kit with Sliding Rails (option)” on page 83,
and fully extend the slide rails until they lock.
b. Connect all the required cables to the component.
c. Place the cables in the cable cutouts and into the cabling channels.
d. Use the supplied straps to secure the cables within the cabling channels.
Notes:
■ Wrap the straps through the back of the cabling channels.
■ Never wrap the straps around the bottom of the cable arm.
Ensure that excess strap length is either cut off, or secured
to the other straps and placed in the cabling channel with the
cables.
e. Press and hold the left and right slide extension release levers and
slowly slide the component throughout its entire range of motion to
ensure that cabling is not strained or restricting movement of the sliding
rails.
Note: Make certain cabling is not pinched when the rails
and cable arm are in the fully retracted position.