User`s guide

User Guide
92
www.bull.com
4. Attach the cable arm (along with the spacer block) to the rear of the sliding rail
using the captive thumbscrews (letter “A” on Figure 57).
5. Open the locking clips on the anti-sag bar slider on both slide rails by lifting
the silver tab.
6. Attach the anti-sag bar to the anti-sag bar sliders on the left and right slide rails.
Figure 58: Attaching the Anti-Sag Bar
7. Place the ends of the anti-sag bar over the pins.
Figure 59: Closing the Anti-Sag Bar Slider
8. Attach the front sliding end of the cable arm to the slide rail track using the
captive thumbscrew.
9. Press and hold the left and right slide extension release levers and slowly move
the slide rails throughout their entire range of motion.
Note: Ensure the cable arm folds and expands without
binding. If binding is noticed, recheck the mounting of the cable
arm.