User`s guide

User Guide
76
www.bull.com
Installing and Removing the Rack Handles
Installing the Rack Handles
1. Make sure the power switches for the computer, video monitor and any
peripheral devices are turned OFF and unplug the power cord (see General
Safety Information” on page 132).
2. If applicable, disconnect the monitor and peripheral devices (printers, for
instance) from the system.
3. Attach the rack handle to the server system with two screws as shown in the
figure below.
Figure 36: Installing the Rack Handle
4. Repeat step 3 on the opposite side of the server.
5. Plug all peripheral devices and the AC power cable into the server.
Removing the Rack Handles
1. Make sure the power switches for the computer, video monitor and any
peripheral devices are turned OFF and unplug the power cord (see General
Safety Information” on page 132).
2. If applicable, disconnect the monitor and peripheral devices (printers, for
instance) from the system.
3. Remove the two screws holding the rack handle in place, and remove the rack
handle from the server system as shown in the figure below.
Figure 37: Removing the Rack Handle
4. Repeat step 3 on the opposite side of the server.
5. Plug all peripheral devices and the AC power cable into the server.