User`s guide

User Guide
70
www.bull.com
a. Position the caged nut on the inside of the front vertical mounting rails.
b. Hook the side lip of a caged nut into the square hole in the rail.
c. Push the other side lip of the caged nut into the square hole in the rail
until it is secured.
d. Repeat for each caged nut.
Figure 31: Inserting a caged nut
4. Repeat steps 1 to 3 for the left support rail.
Attaching the Handles to the Rack Mounting Frame
Two handles are attached to the rack mounting frame. The handles are used to easily
slide the server in and out of the rack.
Warning
The handles are only used to slide the server in and out of the
rack. DO NOT use these handles to carry the server.
Attach the handles (A in "Figure 26: Handles (A), screws (B) and hex key (C)") to the
rack mounting frame with two screws (B in "Figure 26:
Handles (A), screws (B) and
hex key (C)").
Installing the Rack Mounting Frame on the Server
Install the rack mounting frame on the server as follows:
1. Remove the right side door as described in “Removing the Right Side Door” on
page 139.
2. Remove the front panel as described in “Removing the Front Panel” on
page 141.