User`s guide

User Guide
287
www.bull.com
0xE4h R A R OFF Entered EFI driver execution phase (DXE)
0xE5h R A R G Started dispatching drivers
0xE6h R A A OFF Started connecting drivers
0xEBh A R A G Started dispatching a driver
0xECh R A A OFF Completed dispatching a driver
DXE Drivers
0xE7h R A A G Waiting for user input
0xE8h A R R OFF Checking password
0xE9h A R R G Entering BIOS setup
0xEAh A R A OFF Flash update
0xEEh A A A OFF Calling Int 19. One beep unless silent boot is enabled
0xEFh A A A G Reserved for DXE Drivers use
Runtime Phase / EFI Operating System Boot
0xF4h R A R R Entering sleep state
0xF5h R A R A Exiting sleep state
0xF8h A R R R Operating system has requested EFI to close boot services
(ExitBootServices ( ) has been called)
0xF9h A R R A Operating system has switched to virtual address mode
(SetVirtualAddressMap ( ) has been called)
0xFAh A R A R Operating system has requested the system to rest
(ResetSystem ( ) has been called)
Pre-EFI Initialization Module (PEIM) / Recovery
0x30h OFF OFF R R Crisis recovery has been initiated because of a user
request
0x31h OFF OFF R A Crisis recovery has been initiated by software (corrupt
flash)
0x34h OFF G R R Loading Crisis recovery capsule
0x35h OFF G R A Handing off control to the crisis recovery capsule
0x3Fh G G A A Unable to complete crisis recovery
Table 13: Diagnostic LEDs Codes (Continued)
Check Point Diagnostic LED
Decoder
(G=green; R=red; A=amber)
Description
MSB LSB