User`s guide

User Guide
219
www.bull.com
Connecting a SAS/SATA hot swap backplane without expander
Caution
SATA controllers cannot be used with an expander backplane.
1. Connect the two power cables (A) to the power cable connectors on the SAS/
SATA backplane.
2. Connect a SAS/SATA data cable (B) to each appropriate SAS/SATA
connector on the SAS/SATA backplane.
3. Connect the IPMB cable (C).
4. Connect the SES cable to the SAS controller.
5. Connect the fan power to the FAN1 connector on the motherboard.
Figure 167: Connecting the Six-drive SAS/SATA Hot-Swap
Drive Cage Backplane without Expander
(fan bracket not shown in the illustration for clarity)