User`s guide

User Guide
212
www.bull.com
5. Insert the drive into the 5.25-inch device drive bay (C).
6. Line up the holes in the optical disc drive with the holes in the chassis (D).
7. Move the latch to the “lock” position (E).
8. Connect the cable(s) to the rear of the optical disc drive.
Figure 155: Installing an Optical Disc Drive
9. If necessary, remove the filler plate from the front bezel assembly.
10. Replace the front panel. See “Replacing the Front Panel” on page 210.
11. Replace the left side cover. See “Replacing the Left Side Cover” on page 208.
Note: If necessary, modify the BIOS Setup program to
recognise the additional device. For additional information, refer
to “Using the BIOS Setup Utility” on page 288.
TP01723