User`s guide

User Guide

208

www.bull.com

Replacing the Left Side Cover

Avoid damaging your system - before replacing the left side cover, make sure no cables

or other devices protrude from the chassis.

1. Take a few moments to examine the interior side of the cover, and notice the

rails and hooks inside the cover.

2. Leaving about 1 centimetre to slide the cover forward, lay the cover on the

chassis, and check that the rail is ready to slide on its corresponding edge and

that the slots are ready to fit with their corresponding metal hooks. You may

find this procedure easier to follow if you lay the unit on the left side.

3. Slide the cover forward as far as it will go (A), and make sure the cover is

properly inserted; the cover, the chassis and the front bezel should fit squarely

together.

Figure 151: Replacing the left side cover

A: sliding the left side cover forward

B: screws

4. Replace and tighten the screws (B).

TP00831