User`s guide

User Guide
205
www.bull.com
9. Install the PCI riser assembly into the server. Refer to“Installing the PCI Riser
Assembly” on page 201.
10. Install the server cover. Refer to “Installing the Server Cover” on page 161.
11. Plug all peripheral devices and the AC power cable into the server.
Removing a PCI Add-in Card
1. Make sure the power switches for the computer, video monitor and any
peripheral devices are turned OFF and unplug the power cord (see “General
Safety Information” on page 132).
2. Disconnect the monitor and peripheral devices (printers, for instance) from the
system.
3. Remove the server cover. Refer to “
Removing the Server Cover” on page 160.
4. Remove the PCI riser assembly. Refer to “
Removing the PCI Riser Assembly”
on page 200.
5. Remove the screw at the rear of the riser assembly. See letter “A” in
Figure 149.
Note: Save this screw. You will use it later.
6. Pull the add-in card from the socket in the riser assembly. See letter “B” in
Figure 149.
Note: You may need to wriggle the card from front to back
to remove it, but use caution so you do not twist or bend the
card.
7. Install a filler panel over the opening at the rear of the riser assembly. See letter
“C” in Figure 149.
8. Re-install the screw you removed in step 5. See letter “A” in Figure 149.
Figure 149: Removing a Full Height Add-In Card
Note: Make sure that all empty add-in card slots have filler
panels installed.