User`s guide

User Guide
203
www.bull.com
8. Install the replacement riser connector, if desired. For instructions, see
“Installing a PCI Riser Card” on page 203.
9. Install the PCI riser assembly into the server. For instructions, see “Installing
the PCI Riser Assembly” on page 201.
10. Install the server cover. For instructions, see “Installing the Server Cover” on
page 161.
11. Plug all peripheral devices and the AC power cable into the server.
Installing a PCI Riser Card
1. Make sure the power switches for the computer, video monitor and any
peripheral devices are turned OFF and unplug the power cord (see “General
Safety Information” on page 132).
2. Disconnect the monitor and peripheral devices (printers, for instance) from the
system.
3. Remove the server cover. Refer to “Removing the Server Cover” on page 160.
4. Remove the processor air duct. Refer to “
Removing the Processor Air Duct”
on page 162.
5. Disconnect any cables attached to any add-in cards.
6. Remove the PCI riser assembly. Refer to “Removing the PCI Riser Assembly”
on page 200.
7. Remove any add-in cards from the PCI riser connector. Refer to “Removing a
PCI Add-in Card” on page 205.
8. Use two screws to attach the riser card to the riser assembly.
Figure 147: Installing the Riser Card onto the Riser Assembly
9. Install a PCI add-in card if desired. Refer to “Installing a PCI Add-in Card” on
page 204.
10. Install the PCI riser assembly into the server. Refer to“Installing the PCI Riser
Assembly” on page 201.
11. Connect any cables to add-in cards that require them. See your add-in card
documentation for information and add-in card requirements.
12. Re-install the processor air duct. Refer to “
Installing the Processor Air Duct”
on page 163.
13. Install the server cover. Refer to “Installing the Server Cover” on page 161.
14. Plug all peripheral devices and the AC power cable into the server.