User`s guide

User Guide
201
www.bull.com
6. If you need to add or replace a PCI riser connector, see “Installing and
Removing a PCI Riser Card” on page 202.
7. If you need to add or replace a PCI add-in card, see “Installing and Removing a
PCI Add-in Card” on page 204.
8. If you removed the PCI riser assembly for another procedure, continue with
that procedure.
Installing the PCI Riser Assembly
Note: For clarity, the figure in this series of instructions
does not show an attached add-in card. If you are installing an
add-in card, do so before installing the PCI riser assembly into
your server.
1. Lower the riser assembly into place over the add-in card slot. See letter “A” in
Figure 145.
2. Align the three hooks in the riser assembly with the matching slots at the back
of the server. See letter “B” in the figure below.
Figure 145: Installing PCI Riser Assembly
3. Press down uniformly until the two hooks on the rear of the PCI riser assembly
engage the server back panel slots. The riser cards will seat into the matching
sockets on the server board.
4. Connect any cables to add-in cards that require them. See your add-in card
documentation for information and add-in card requirements.
5. Replace the server cover. Refer to “
Installing the Server Cover” on page 161.