User`s guide

User Guide

190

www.bull.com

10. Lift the fan from the bracket. See letter “B” in the figure below.

Figure 133: Removing Fan from Fan Bracket

11. Install the replacement fan onto the bracket, using the two screws you removed

in step 9.

12. Set the fan assembly into the system. Insert the rear edge first and push the

assembly slightly rearward to clear the hard disk drive brackets. Use caution to

make sure you do not pinch any cables.

13. Route the cable from the fan at the right around the right side of the assembly

and under the clip at the front of the fan bracket.

14. Connect the fans to the server board. See letters “A” and “B” in the figure

below.

Figure 134: Connecting System Blower Fans

15. Install the processor air duct. Refer to “Installing the Processor Air Duct” on

page 163.

16. Replace the server cover. Refer to “

Installing the Server Cover” on page 161.

17. Plug all peripheral devices and the AC power cable into the server.