User`s guide

User Guide

183

www.bull.com

8. Insert the replacement power supply at an angle into the server, sliding the

power connector side in first to fit it through the cut-out area at the rear of the

system. See letter “A” in Figure 127.

9. Set the front of the power supply down pushing the power supply back so it fits

behind the foot at the bottom of the chassis. See letter “B” in Figure 127.

10. Insert the screw you removed in step 5 to attach the power supply to the server.

See letter “C”.

Figure 127: Installing Power Supply Module into the System

11. Connect the power supply cables to the server board and peripherals.

A: 2x4 power connector

B: 2x12 main power connector

C: Daisy chain cable to:

- HDD1 power connector, if a hard drive is installed here. Use the connec-

tor on cable that is closest to power supply.

- HDD0 power connector, if a hard drive is installed here. Use the center

connector on the cable.

AF002475