User`s guide

User Guide
179
www.bull.com
10. Place the server board into the server as shown by letter “A” in Figure 124.
11. Attach the server board with nine screws. See letter “B” in the figure below.
Figure 124: Installing the Server Board
12. Install the processor. Refer to “Installing a Processor” on page 195.
13. Install the DIMMs. Refer to “Removing and Replacing a DDR2 module” on
page 198.
14. Install the PCI riser assembly. Refer to “Installing the PCI Riser Assembly” on
page 201.
15. Reconnect all cables to the server board. For a full cabling diagram, refer to
“Cable Routing” on page 192.
16. Install the processor air duct. Refer to “Installing the Processor Air Duct” on
page 163.
17. Replace the server cover. Refer to “
Installing the Server Cover” on page 161.
18. Plug all peripheral devices and the AC power cable into the server.