User`s guide

User Guide
176
www.bull.com
We strongly recommended you use special software or service
for data erasure in order to avoid any troubles. For details on
data erasure, ask your sales representative.
Note: If you are installing a new drive, skip the rest of these
steps and instead see
“Installing a Hard Disk Drive” on
page 171, beginning with step 8.
9. Insert the screws that held the drive in the carrier into the screw locations on
the carrier for future use.
10. Set the drive assembly into place in the chassis. See letter “A” in the figure
below.
11. Attach the drive assembly to the chassis with the screw that you removed in
Step 6. See letter “B” in the figure below.
Note: The assembly that contains the optical drive bracket
must be installed at the left side of the system.
Figure 122: Installing the Drive Carrier
12. Replace the server cover. Refer to “Installing the Server Cover” on page 161.