User`s guide

User Guide
173
www.bull.com
10. Set the drive assembly into place in the chassis. See letter “A” in the figure
below.
11. Attach the drive assembly to the chassis with the screw that you removed in
Step 6. See letter “B” in the figure below.
Note: The assembly that contains the optical drive bracket
must be installed at the left side of the system..
Figure 119: Installing the Drive Assembly
- HDD1 only: Route the power cable into the cable clip on the top of the
hard drive bracket. See letter “A” in Figure 120.
12. Connect the data cables to the drive(s).
■ If a drive is installed in the HDD0 carrier, connect the HDD0 data cable
to the SATA 1 connector on the server board. See letter “B” in
Figure 120.
■ If a drive is installed in the HDD1 carrier, connect the HDD1 data cable
to the SATA 2 connector on the server board. See letter “C” in
Figure 120.
Note: The data cables are factory routed underneath the
fan module. Use caution to make sure you connect the connect
cables between the server board and the hard drives. The
cables are labeled at each end.
13. Connect the power cables to the drive(s):
■ If a drive is installed in the HDD1 carrier, attach the connector on the
daisy chain power cable that is closest to the power supply to the HDD1
connector. See letter “E” in Figure 120.