User`s guide

User Guide
171
www.bull.com
Installing a Hard Disk Drive
1. Make sure the power switches for the computer, video monitor and any
peripheral devices are turned OFF and unplug the power cord (see “General
Safety Information” on page 132).
2. Disconnect the monitor and peripheral devices (printers, for instance) from the
system.
3. Remove the server cover. Refer to “Removing the Server Cover” on page 160.
4. Locate the drive position you want to use.
Figure 116: Locating Drive Positions
- HDD1 location only: Slide the power cables from the cable clip that is
located on the top of the hard drive carrier.
5. Remove the screw that holds the hard drive bracket to the chassis. See letter
“A” in the figure below.
Note: Save this screw. You will use it to reinstall the drive
assembly later.