User`s guide

User Guide
167
www.bull.com
Removing a Slimline Optical Drive
1. Make sure the power switches for the computer, video monitor and any
peripheral devices are turned OFF and unplug the power cord (see “General
Safety Information” on page 132).
2. Disconnect the monitor and peripheral devices (printers, for instance) from the
system.
3. Remove the server cover. Refer to “Removing the Server Cover” on page 160.
4. Remove the bezel if it is installed. Refer to “Removing the Front Bezel” on
page 158 .
5. Note the orientation of the PCI cooling fan that is located behind the optical
drive bay, then lift the fan from the mounting pegs. It is not necessary to
disconnect the fan cable. See letter “A” in the figure below.
Figure 112: Lifting the PCI Cooling Fan from the Mounting Pegs
6. Disconnect the optical drive power and data cables. See letters “A” and “B” in
Figure 113.
7. Remove the screw that holds the optical drive bracket to the server chassis. See
letter “C” in Figure 113
.
Note: Save this screw. You will reinstall it later.