User`s guide

User Guide
145
www.bull.com
Installing or Removing Hard Disk Drives
Removing a Hard Disk Drive
1. Remove the right side door. See “Removing the Right Side Door” on page 139.
2. Loosen the screw (A) securing the HDD bracket and the 3.5/5.25-inch bracket
together.
3. Locate the HDD bracket latch (B).
Figure 91: HDD Bracket Screw and Latch
4. Disconnect the data cable and the power cable from each installed hard disk
drive.
Caution
Be careful when working around the cables connected to the
already installed drives.
If necessary disconnect these cables, but be sure to note which
device each cable or power lead was attached to.