User`s guide

User Guide
110
www.bull.com
Hot-Swapping a Power Module
Warning
Hazardous voltage, current, and energy levels are present
inside the power supply. There are no user-serviceable parts
inside it; servicing of the power supply should be done only by
technically qualified personnel.
1. Observe the safety and ESD precautions listed in “General Safety
Information” on page 132.
2. Remove the power cable from the defective power supply.
Warning
Put on protective gloves before you follow the instructions
below. The power modules are very hot and there is a risk of
severe burns.
3. Press up on the green latch (A) while pulling on the handle (B) to remove the
hot-swap power supply from the chassis.
Figure 77: Removing the Hot Swap Power Supply Module from the Chassis
4. Insert the new hot swap power supply module.
Figure 78: Inserting Hot Swap Power Supply Module in Chassis
5. Connect the power cable to the replaced hot swap power supply.
TP00856
A
B
TP00854