User`s guide

User Guide
101
www.bull.com
Push the other side lip of the caged nut into the square hole in the rail
until it is secured.
Figure 74: Inserting a caged nut
4. Repeat steps 1 to 3 for the left support rail.
Installing the Filler on the Server
Install the filler on the server as follows:
1. Remove the right side door as described in Removing or Installing the Left
side cover” on page 207.
2. Remove the four plastic plugs from the top side cover.
Figure 75: Removing the Plastic Plugs from the Top Side Cover
3. Install the filler on the top of the cover using four flangehead screws. The
handles must face the front of the server.
4. Replace the top side cover.
TP02004