Installation guide

User Guide
25
www.bull.com
■ To configure ALB, connect the network adapters only to the
L2 switching hub.
■ To replace a motherboard or an optional network card, you
must first remove the team and create it again after the
replacement.
Network Driver
Changing a link speed
Follow the steps below to set a link speed and duplex mode. To set an IP address, make
sure that the Internet Protocol Version (TCP/IP) box is checked.
1. Open Control Panel. Under System and Maintenance, click Open Device
Manager
to start Device Manager.
2. Open Network adapters, and double-click Intel(R)~.
3. Click Link Speed, and set the same values for Speed and Duplex as those for
the switching hubs.
4. In the Property dialog box, click OK.
SCSI Controller
Adaptec SCSI Card 29320ALP
Adaptec SCSI Card 29160LP
Adaptec SCSI card 29320LPE
You do not need to install the driver manually, it is automatically installed by Windows
Plud-and-Play.