Installation guide

User Guide
24
www.bull.com
2. Open Network adapters, and double-click Intel(R)~.
3. Select the Teaming tab, select Team adapter with other adapters, and click New
Team…
.
4. Type a team name, and click Next.
5. Confirm the adapters to include in the team, and click Next.
6. Select Adapter Fault Tolerance or Adaptive Load Balancing as a team mode,
and click Next.
7. Click Finish.
8. In Device Manager, double-click a teamed adapter to see its property. Select the
Settings tab, and click Modify Team….
9. To set an adapter to primary, select the adapter, and click Set Primary.
To set an adapter to secondary, select the adapter, and click Set Secondary.
After both the primary and the secondary adapters are selected, click OK to
close the screen.
To confirm the team settings:
Open the team property, and select the Settings tab. The setting for each
adapter is shown in Adapters in team.
10. In the Settings tab, click Test Switch.... When the switch test screen appears,
click Run Test.
When No problems ∼ appears, the test is complete.
Restart the system.
Removing a Team
1. Open Control Panel. Under System and Maintenance, click Open Device
Manager
to start Device Manager.
2. Open Network adapters, and double-click a teamed adapter.
3. Select the
Settings tab, and click Remove Team.
4. When the Team Settings pop-up box appears, click Yes.
5. Under
Device Manager, go to Network adapters. Make sure that no adapter is
teamed.
Restart the system.
Caution
■ Adapter Fault Tolerance (AFT) and Adaptive Load Balancing
(ALB) are not available when ServerCore is in use.
■ Be sure to configure AFT and ALB after you boot the system
following the driver installation.
■ To use AFT, we recommend you to connect the network
adapters to the same L2 switching hub. You may use differ-
ent switching hubs, but cascade them over the same net-
work.