User`s guide

Setting Up Your Server 3-9
Installing Rail Assemblies
1.
Insert the square projection of the rail assembly into the angle hole on the 19-inch rack until you hear a click : the rail
assembly is locked.
The figure below shows the right side (front) of the rack. Install the rail assemblies to the right side (rear), and left
side (front and rear) of the rack using the same procedure.
Make sure that the rail assembly is installed at the same level as the other slide rail assembly already installed.
NOTES:
 There may be some backlashes in the front and rear, however, it is not a deficiency.
 Make sure that the rail assembly is surely locked to the rack.