User`s guide
General Description 2-35
5. As shown in the figure below, hold the tray with a hand and press the disc with fingers of another hand to make the
hole of the disc fit to the rotor at the center of the tray.
Roto
r
Press this part of disc.
6. Push the front of the tray lightly to retract it into the drive.
IMPORTANT: If a noisy sound in driving the optical disk drive occurs after setting a disc, set it
again correctly.
To take out the disc from the optical disk drive, press the Eject button in the similar way in setting the disc to make the tray go
out.
If the access LED is lit, the disc is being accessed. Confirm that the access LED is not lit before pressing the Eject button.
As shown in the figure below, hold the tray with a hand and take the end of the disc lightly by the fingers of another hand with
the suppression of the rotor at the center of the tray to remove the disc from the tray.