User`s guide

F-10 Installing Windows Server 2003
Press Enter, and go to Step 13.
13. When the following message is shown, press Enter to start "Welcome to Setup".
IMPORTANT: If you install Windows Server 2003 on the hard disk larger than 2,097,152MB
(2TB), you can specify only a value equal to or less than 2,097,152MB as partition size.
14. When the installation of Windows Server 2003 has finished, the system reboots automatically.
– Windows Server 2003 has installed: Go on the step 14
– Windows Server 2003 R2 has installed: Go on the step 11
15. When Windows Server 2003 R2 has been installed, the [Windows Setup] screen will be displayed after logged on to
the system.
IMPORTANT:
 In this case, the [Windows Setup] screen may not be displayed.
Be sure to install Microsoft Windows Server 2003 R2 DISC 2 according to the following
procedures.
 You can install Microsoft Windows Server 2003 R2 DISC 2 after the application of "System
update".
Be sure to install Microsoft Windows Server 2003 R2 DISC 2.
In this case, note that the [Windows Setup] screen is not displayed.
16. Insert Microsoft Windows Server 2003 R2 DISC 2 CD-ROM into the optical disk drive.
Confirm the parameters and click [OK].
17. When the installation has completed, remove Microsoft Windows Server 2003 R2 DISC 2 CD-ROM from the optical
disk drive, and restart the system.
18. When the installation has completed, be sure to execute the tasks described in "Driver Installation and Advanced
Settings" and "Updating the System" of manual.