User`s guide

F-6 Installing Windows Server 2003
Creating "Windows Server 2003 OEM-Disk for EXPRESSBUILDER"
Before installing, create Windows Server 2003 OEM-Disk for EXPRESSBUILDER.
NOTE: If you have already "Windows Server 2003 OEM-Disk for EXPRESSBUILDER" for
NovaScale R440 E2 Server which you are going to install Windows Server 2003, you do not need
to create it again.
You can create Windows Server 2003 OEM-Disk for EXPRESSBUILDER with the following two procedures.
Create from the menu which appears when running NovaScale R440 E2 Server with ExpressBuilder.
If you have only NovaScale R440 E2 Server to create Windows Server 2003 OEM-Disk for EXPRESSBUILDER, use this
procedure.
If Windows Server 2003 or Windows can be operated on NovaScale R440 E2 Server, you can use the other procedure
described later.
Follow the steps below.
1. Prepare one 3.5-inch floppy disk.
2. Turn on your Bull Server.
3. Insert the ExpressBuilder DVD into the optical disk drive of the server.
4. Press the RESET switch or press Ctrl, Alt and Delete to reboot the server. (You may also turn off and then on again
to reboot the server.)
The system will boot from the DVD-ROM and ExpressBuilder starts.
5. Select [Create the OEM-DISK for Windows] from [Tools Menu] step.
6. Insert a floppy disk into the floppy disk drive.
7. Select [Create an Windows Server 2003 OEM-Disk for EXPRESSBUILDER] at [Create OEM-Disk] and click
[Perform].
8. Windows Server 2003 OEM-Disk for EXPRESSBUILDER will be created.
Write-protect and attach a label, then keep it safely.