User`s guide

E-18 Installing Windows Server 2003 X64 Editions
Setup Teaming
IMPORTANT:
 AFT/ALB setting must be done after System Update completed.
 Intel Pro/1000 GT and Intel Pro/1000 PT adapters do not support SFT.
 Please confirm the port setting of switching hub (L2) matches the server network adapter
Teaming mode.
1. Open the [Device Manager].
2. Open [Network adapters] → [Intel(R) xxx] properties.
3. Click [Teaming] tab and check the [Team this adapter with other adapters] check box.
Click [New Team].
4. Fill the name of the team in [Specify a name for the team] and click [Next].
5. Include the adapter to the team and click [Next].
6. Select a team type ([Adapter Fault Tolerance]/[Adaptive Load Balancing]).
Click [Next].
7. Click [Finish].
8. Click [TEAM: "Team name"] from [Device manager] → [Network adapters] to modify the team. Click [Settings] tab
and click [Modify Team] button.
9. Refer to the following procedure to set the team member adapter priority status.
– Set Primary
Point the adapter and click [Set Primary] button.
– Set Secondary
Point the adapter and click [Set Secondary] button.
NOTE: Adapter priority config can be confirmed by the following procedure:
1. Click [TEAM: "Team name"] from [Device manager]→[Network adapters].
2. Click [Settings] and confirm Adapters in team list.
10. Click [Test Switch] → [Run test] to confirm the adapter team is properly setup.
Confirm the result in [Test results].
11. Reboot the system.
Remove Team
1. Open the [Device Manager].
2. Click [Network adapters], and open [TEAM: "Team name"] properties.
3. Click [Setting] tab.
4. Click [Remove Team] button.
5. Click [Yes] to the message.
6. Confirm [TEAM: "Team name"] adapter in not existing in [Network adapters] tree and reboot the system.