User`s guide

E-16 Installing Windows Server 2003 X64 Editions
Network Driver
Specify the details of network driver.
One standard network driver that is mounted will be installed automatically, but the link speed and Duplex mode need to be
specified manually.
IP addresses is not be able to set when the "Internet Protocol (TCP/IP)" check box OFF.
This phenomenon will occur with the certain condition.
Check ON the "Internet Protocol (TCP/IP)" check box and IP address will be able to set.
When PROSet is not installed
1. Open the [Device Manager]
2. Double-click [(Network Adapter Name)] in the list.
3. Click the [Advanced] and specify the [Link Speed & Duplex] value the same as the value specified for HUB.
4. Click [OK].
When PROSet is installed
1. Open the [Device Manager]
2. Double-click [(Network Adapter Name)] in the list.
3. Click the [Link Speed] and specify the [Speed & Duplex] value the same as the value specified for HUB.
4. Click [OK].
Also, add or delete any protocols and services if necessary.
You can operate the process on the property dialog box for local area network which can be appeared from [Network and
Dial-up Connection].
NOTE: It is recommend to add [Network Monitor] at [Adding Services]. [Network Monitor] can
monitor the frame (or the packet) that the computer installing [Network Monitor] sends or receives.
This tool is valuable when analyzing network trouble. For information on how to install the tool,
see the "Setting for Solving Problems" described later in this chapter.
Re-install the Network Driver
The network driver will be installed automatically.