User`s guide

E-8 Installing Windows Server 2003 X64 Editions
The screen of Step 5 is displayed.
– [LSI MegaRAID SAS RAID Controller Driver (Server 2003 for x64)]
(When Internal RAID Controller is installed.)
– [LSI MegaRAID SAS RAID Controller Driver (Server 2003 for x64)]
(When LSI Logic SAS CTRL 8708EM2 RAID Controller is installed.)
– [LSI Embedded MegaRAID (Windows XP/2003 64-bit)]
(When Onboard RAID Controller (LSI Embedded MegaRAID™) is used.)
9. <If the SCSI Controller ADAPTEC 29320ALP or Adaptec ASC-29320LPE is connected>
Press S.
The screen of Step 6 is displayed. Press Enter, and go to Step 10.
<If the SCSI Controller ADAPTEC 29320ALP or Adaptec ASC-29320LPE is not connected>
Press Enter, and go to Step 11.
10. A list of mass storage devices is displayed.
Select the [Adaptec Ultra320 SCSI Cards (Windows 64-bit)] and press Enter.
IMPORTANT: If the following message is displayed when you use the ADAPTEC 29320ALP or
Adaptec ASC-29320LPE SCSI controller, press S.
T
he driver you provided seems to be newe
r
than the Windows default driver.
Windows already has a driver that you can use
for "Adaptec Ultra 320 SCSI Cards
(Windows64-bit)"
Unless the device manufacturer prefers that
y
ou use the driver on the floppy disk, you
should use the driver in Windows.
The screen of Step 5 is displayed.
Press Enter, and go to Step 11.
11. When the following message is shown, press Enter to start "Welcome to Setup".
IMPORTANT: If you install Windows Server 2003 x64 Editions on the hard disk larger than
2,097,152MB (2TB), you can specify only a value equal to or less than 2,097,152MB as partition
size.
12. When the installation of Windows Server 2003 x64 Edition has finished, the system reboots automatically.
13. The [Windows Setup] screen will be displayed after logged on to the system.