User`s guide

Appendix B
Other Precautions
Transfer Rate of the On-board LAN controller
The mother board includes the two network interface controllers that supports 10Base-T, 100Base-TX, and 1000Base-T
networks and a capable of full or half duplex.
Both controllers can automatically detect and switch for network speed and transfer mode connected to the HUB. However, for
proper network operation, specify the "Link Speed & Duplex" value the same as the value specified for HUB.
Server Management Software
The ExpressBuilder DVD that comes with the server contains the NEC ESMPRO utility.
Bull recommends that you should install the NEC ESMPRO for effective use of the reliability enhancement features of the
server.
Floppy Disk
The following describes use of the floppy disk.
Floppy disk type
The server uses 3.5-inch floppy disks. You can use the following two types of 3.5-inch floppy disks:
 2HD floppy disk (double-sided high-density track type)
Stores data of 1.44MB.
 2DD floppy disk (double-sided double-density track type)
Stores data of 720KB.
Shutter
Insertion direction
indicator
Centering hub
Catching hole
Head window
Centering hole
Label
RearFront
High-density media hole
(2HD only)
Write protection switch
Write protection
hole
Notes on use
The floppy disk is an important data storage media with delicate structure and requires care. Keep the following notes in mind
to use it:
 Insert the floppy disk into the floppy disk drive gently as far as it goes.
 Attach the label to the correct position.
 Do not write anything directly onto the disk surface with a pencil or ball-point pen.
 Do not open the shutter.
 Do not use the floppy disk in a dusty place.
 Do not place anything on the floppy disk.
 Do not leave the floppy disk in a high-temperature place (e.g., place exposed to direct sunlight or close to a heater).