User`s guide

Upgrading Your Server 9-51
IMPORTANT:
 Do not touch the terminals of the riser cards and PCI boards with your bare hand. Fingerprints
and dust left on them may cause the server to malfunction.
 If the PCI board is not installed correctly, remove it, and then install it again. Be careful not
to apply excess force to a PCI board or riser card. Doing so may damage the card.
NOTES:
 Confirm that the end of the PCI board bracket is inserted in the frame slot of the riser card.
 Some PCI boards have terminal section that extends over the mating connector.
7. Secure the PCI board with the screw removed at step 5.
IMPORTANT: This step is to protect the terminals of the riser card from dust or fingerprints.
Dust and fingerprints left on them may cause the server to malfunction.
Low-Profile side Full-height side