User`s guide

2-6 General Description
Rear View
1 Full-height PCI board slot
Mount PCI board of the full-height type in the slot.
2 Low-profile PCI board slot
Mount PCI board of the low-profile type into this slot.
NOTE: If an additional LAN board is installed, it is hard to push the catch of the connector
with your finger that is connected to the LAN board. Disconnect the connector
pushing the catch with a standard screwdriver. At this time, be very careful for the
screwdriver not to damage the LAN board.
3 Blank panel (for additional power supply unit)
Install an optional power supply unit in this slot.
4 Power supply unit
Factory-installed power supply unit
5 AC inlet
Connect the power cord to this socket.
6 Mouse connector
Connect the mouse to this connector.
7 Keyboard connector
Connect the keyboard to this connector.
8 LINK/ACT LED (green)
This LED indicates the access status of the LAN.
9 Speed LED (green/amber)
This LED indicates the transmission speed of the LAN.
10 LAN connectors
Connect network systems on the LAN to the connectors
(1000BASE-T/100BASE-TX/10BASE-T).
The number "1" following the parenthesized number indicates LAN port 1, and the number
"2" indicates LAN port 2.
If [Shared BMC LAN] is set to [Enabled] in BIOS SETUP, the LAN port 2 can be used as
management LAN, and not only as a transmission port. However, it is not recommended for
performance and security reasons, because the LAN port 2 may receive both normal data
and management data.