User`s guide

Troubleshooting 8-33
Problems with ExpressBuilder
When the server is not booted from the ExpressBuilder DVD, check the following:
 Did you insert the ExpressBuilder during POST and restart the server?
→ If you do not insert the ExpressBuilder during POST and restart the server, an error message will appear or
the OS will boot.
 Is BIOS configuration correct?
→ The boot device order may be specified with the BIOS SETUP utility of the server. Use the BIOS SETUP
utility to change the boot device order to boot the system from the optical disk drive first.
<Menu to check: [Boot]>
 If [Os installation ***default***] is selected at Boot selection screen, following message is displayed.
After this message appears, check the error and take the appropriate corrective action according to the
message listed in the table below.
Message Cause
This ExpressBuilder version was not
designed for this computer.
Insert the correct version and click [OK].
(When you click [OK], the computer reboots.)
This ExpressBuilder version is not
designed for this server.
Execute the ExpressBuilder on the
compliant server.
ExpressBuilder could not get the hardware
parameters written in this motherboard.
This version is not designed for this computer
or the motherboard may be broken. (When
you click [OK], the computer reboots.)
The hardware parameters written in this
motherboard are incorrect.
This version is not designed for this computer
or the motherboard may be broken.
This message is shown when
ExpressBuilder could not find
system-specific information because
of mother board exchange and so on.