User`s guide

Troubleshooting 8-31

The PXE boot (network boot) fails or the server is not found on the network:

 Is the cable connected properly?

→ Connect the proper cable to the network port on the rear of the Bull server. In addition, make sure that the

used cable conforms to the network interface standard.

 Is BIOS configuration correct?

→ The internal LAN controller may be disabled with the BIOS SETUP utility of the server. Check the setting

with the BIOS setup utility.

 Have the protocol and service been already configured?

→ Install the distinctive network driver for the server. Make sure that the protocol, such as TCP/IP, and services

are properly specified.

 Is the transfer speed correct?

→ Open the network property dialog box in the control panel to specify the link speed and duplex value (the

same as the value specified for HUB).

The Telnet Service is not installed.

→

Adjust the computer name to 14 characters or less, and then install the Telnet Service according to <How to

install the Telnet Service>.

1. Click [Run] on Start menu.

2. Type "tlntsvr /service" in the [Open] box, and click [OK].

3. Click Start menu, point to [Control Panel] and click [Computer Management] and then click the [Services] to specify

whether the Telnet Service is registered.

* When the installation of Telnet Service is finished, there is no problem if the computer name is set to 15

characters or more.