User`s guide

8-30 Troubleshooting
During installation, the following warning is registered in the System Log of the Event Viewer:
Error detected on the device \Device\CdRom0 during the paging operation.
→ There is no problem with this issue.
Fail to start the OS:
 Is a floppy disk in the floppy disk drive?
→ Take out the floppy disk and restart the server.
 Is the ExpressBuilder DVD in the optical disk drive?
→ Take out the ExpressBuilder DVD and restart the server.
 Is the OS broken?
→ Use the recovery process to recover the system.
The OS presents unstable operation:
 Did you update the system?
→ Installing a network drive after installation of the OS may cause unstable operation. Use the ExpressBuilder
DVD to update the system. (See Chapter 6.)
The system does not restart automatically when a stop error occurs, though the system is adjusted to automatically
restarting:
→
When the system does not restart automatically, restart it manually.
The system restarts automatically when a stop error occurs, though the system is NOT adjusted to automatically
restarting:
→
There is no problem about this issue.
Check the System Event Log to confirm that STOP error occurred.
Cannot turn the power OFF at the blue screen:
→ If you want to turn off the power at the blue screen, execute forced shutdown (forced shutdown: continue to
press POWER switch for 4 seconds). The power will not be turned off if you press the switch for less than 3
seconds.